加入收藏 | 联系我们 | English

联系人:张经理

联系电话:0512-68794091  

移动电话:18913142510
传真:0512-68361260  
网址:www.jiangsuqizhongji.com

行业资讯

桥式起重机啃轨解决方法

远华起重 时间:2012-12-03 点击:1185次

摘要:桥式起重机啃轨解决方法....……
一:我们需要重视车轮修整事情,如果桥式起重机两个主动车轮的直径已经大于0.2毫米,并且被动轮也达到0.5毫米。这时需要重新安置车轮,从而使主动轮和被动轮两者之间的距离不能超过3毫米。同时,还需要重视车轮跨度,对角线、车轮同位差。如果它们的直径都超过规定的范围,可以把桥式起重机两边的车轮轴承安置在间隔环中。
A: we need to pay attention to the wheel dressing things, if the bridge crane two driving wheel diameter is greater than 0.2 mm, and the driven wheel is up to 0.5 mm. When the need to relocate the wheels, so that between the driving wheel and the driven wheel and the distance between not exceeding 3 mm. At the same time, also need to pay attention to the wheel span, diagonal, wheel idiostatic. If they have a diameter of more than the prescribed range, can be the bridge crane on both sides of the wheel bearing arranged on the spacer ring in.
二:桥式起重机的轨道整修,分析造成桥式起重机啃轨的原因,检查轨道的水平度、直线度、踏面垂直,查看是否超过实际标准。如果是这样的话,需要对轨道的接头进行焊接。
Two: the bridge crane rail refurbishment, the analysis of the cause of biting rail bridge crane, check the track levelness and straightness, tread vertical, check to see if more than the actual standard. If this is the case, need for rail welding joint.
三:此外,我们也可以检查桥式起重机的桥架、抓斗、制动器等零部件。
Three: in addition, we can also check the bridge crane, grab, such as brake parts.
桥式起重机http://www.jiangsuqizhongji.com/ 

版权所有:苏州远华起重设备有限公司Copyright(c)2015
地址:江苏省苏州市高新区迎宾路20号 电话:0512-68794091 传真:0512-68361260 苏ICP备12065182号
专业桥式起重机-门式起重机-欧式起重机-电动葫芦供应商

点击这里给我发消息 点击这里给我发消息